Skip to content
ChizhenkaCHIZHENKAHedgehog Aid Community
Back to the card
Low risk

Card 36B. Continuous oxygen support: concentrator / cylinder with a flowmeter

▤ Print-friendly version

When needed: an oxygen concentrator, medical oxygen cylinder with a flowmeter or professional oxygen chamber is available.

Main principle: when a continuous source is available, constant controlled delivery is preferable to pulses. The chamber remains ventilated; oxygen concentration, carbon dioxide and temperature matter more than attempts to make it airtight.

1. If a professional oxygen cage/incubator is available, follow its standard protocol. Prefer a system that measures oxygen, carbon dioxide, temperature and humidity and provides carbon dioxide removal.

2. If a small transparent container of 8–10 L is used as a temporary chamber, retain the arrangement in Card 36A: a low inlet, 6 holes of 8 mm high on the opposite wall, and a lid without an airtight gasket.

ParameterWorking guide
Initial flow into an 8–10 L chamber1–2 L/min for 2–3 minutes to enrich the chamber rapidly.
Subsequent flowUsually 0.5–1 L/min with continuous observation and open ventilation.
If an oxygen sensor is availableThe working target for stabilising most patients is approximately 40–60% O₂. Do not maintain >60% for hours without clinical need and monitoring.
If a CO₂ sensor is availableAim for a level close to room air; if it rises above 2500 ppm, increase gas removal/ventilation.
TemperatureMonitor continuously. As it approaches 28 °C, remove external heat and improve ventilation; do not use a chamber that is overheating.

3. Connect a concentrator or medical oxygen cylinder only through a functioning flowmeter. Do not direct the tubing straight at the face.

4. Position the compressor or concentrator so that vibration and noise are farther from the hedgehog. Do not use noise as “stimulation”: minimising stress remains part of care.

5. During transport, a continuous source is preferable to a canister if it is safely secured and designed to operate during travel. All ventilation holes must remain unobstructed; do not cover the chamber with a blanket.

6. Improvement with oxygen does not remove the need for diagnosis. If increasing respiratory effort, cyanosis, inadequate lung ventilation, collapse or respiratory arrest persists, intubation/mechanical ventilation and treatment of the cause may be required. Criteria for safe continuous support: oxygen passes through a flowmeter, the chamber is continuously ventilated, the animal is visible and observed, and oxygen/carbon dioxide/temperature are monitored as fully as the equipment allows.

Notes

Veterinary sources for oxygen hood systems specify an initial flow of around 1–2 L/min and maintenance flow of 0.5–1 L/min; commercial oxygen cages typically operate at approximately 40–60% oxygen. In a small homemade container, the actual concentration depends on leaks and ventilation, so a sensor is more important than a calculated figure. Merck emphasises the need to monitor oxygen, carbon dioxide, temperature and humidity; CO₂ rising above 2500 ppm is a reason to increase ventilation/gas removal. Sources: Merck Veterinary Manual; Clinician’s Brief; Today’s Veterinary Practice; veterinary emergency and critical care manuals.