When needed: laboured breathing when oxygen is available, but placing the animal in a chamber currently increases stress or the chamber is not yet ready. “Flow-by” means delivering oxygen beside the face without a mask or an airtight seal. It is a rapid temporary way to start support with minimal restraint.
1. Use medical oxygen from a concentrator or cylinder with tubing. Do not direct a strong, cold jet straight into the nostrils.
2. Initial working flow: 1 L/min. Hold the end of the tubing approximately 5 cm to the side of the face so that the oxygen mixes with ambient air and the hedgehog can breathe freely.
3. If the animal tolerates the flow calmly, it may be increased to 2 L/min. Do not press the tubing against the nose or cover the face with a mask without an appropriate veterinary system.
4. Assess breathing after 2–3 minutes: respiratory effort, mouth opening, the colour of visible mucous membranes, responsiveness and stress level. If the jet causes the animal to pull its head away or panic, increase the distance to approximately 10 cm or switch to a flow-through chamber.
5. This is a temporary method for a few minutes while a less stressful delivery method or transport is being prepared. Do not leave the hedgehog unattended.
DO NOT: enclose the head airtight; direct a strong, cold jet straight into the nostrils; leave an operating oxygen source unattended.
Next steps If a chamber is needed → Card 36A (pharmacy oxygen canister) or Card 36B (continuous oxygen source). Monitoring during oxygen support → Card 39.
Notes
The distance and flow constitute a conservative working standard for use at home, without promising a specific oxygen concentration at the face: this depends on air movement and the animal’s position. Flow-by delivery uses oxygen less efficiently than a chamber but allows support to begin immediately without additional struggling. Sources: Merck Veterinary Manual; Clinician’s Brief; Veterinary Partner / general veterinary principles of oxygen support.
