Skip to content
ChizhenkaCHIZHENKAHedgehog Aid Community
Back to the card
Low risk

Card 27. Pre-release enclosure: assembly and safety checks

▤ Print-friendly version

Build the enclosure before introducing the animal, choosing the site under Cards 26 and 32. If the site is suitable only for acclimatisation, keep the exit closed until safe release.

Prepare: boards or fine galvanised mesh, external posts, fixings, tools for the lower barrier, a smooth anti-climb strip, a house, shelters, a heavy bowl, a feeding point, an infrared camera and a lockable two-way exit.

Dimensions and construction requirements

ElementWorking standardCheck
AreaAt least 4 m² per hedgehog, preferably closer to 10 m²No traps or inaccessible pockets; space for foraging and shelters.
WallsAt least 50 cm high, fixings on the outsideNo low sections, sagging, footholds or gaps.
Fence baseBury approximately 15 cm; deeper in loose soil, or use an anti-dig apronThe edge cannot be undermined or lifted; check the entire perimeter.
Top of meshSmooth strip, overhanging inwards by 10–15 cmNo ‘ladder’ formed by mesh, posts or branches.
HouseDry, stable, shaded; entrance approximately 10 × 10 cm; a second entrance if possibleAway from the wall, stays dry; entrance unobstructed.
Food and waterFeeding point separate from house and exit; heavy shallow ceramic bowlFood does not attract animals to the exit; water cannot be tipped over.
ExitAt ground level, two-way, 13 × 13 cm; corridor approximately 30–40 cmSmooth edges; locked before release, allows return afterwards.

Assembly and testing

1. Choose a level site not prone to flooding, with natural soil, grass and shelters, protected from pesticides, rodenticides and major road impacts.

2. Remove garden netting, fishing line, threads, sharp components, glue traps, open pipes and pits. Any nearby pond must have a reliable gently sloping, rough-surfaced exit.

3. Secure the fence without gaps, and construct the lower and upper barriers as specified in the table; position posts and crossbars outside. Test whether a dog’s paw could lift, push apart or open the structure.

4. Place the house in shade and away from walls; use dry leaves and safe grass as bedding. Exclude cotton wool, long threads, fraying fabric and synthetic fibres.

5. Retain natural vegetation, leaves, branches, fallen wood and foraging areas; add safe shelters to a bare site. Do not cover the entire ground with smooth material.

6. Position water, food and the infrared camera according to the table; install the low two-way gate and check it from both sides without the hedgehog. Keep the exit locked until acclimatisation is complete.

7. Leave the empty enclosure for 2–3 nights. Review infrared recordings of visits by dogs, cats, foxes and badgers; check gaps, damage, digging and fixings every morning. Do not introduce the animal until defects have been rectified.

8. After introduction, inspect the perimeter, walls, top, house, food and water daily; inspect immediately after heavy rain, wind or an attempted intrusion. Wash bowls with hot water.

Next steps. Hedgehog readiness and weather → Cards 25 and 31; enclosed acclimatisation → 28; video monitoring → 29; opening and support → 30 and 33. If the outside area is unsafe, do not open the exit.

Notes

Igelzentrum Zürich and Pro Igel recommend an enclosure of at least 4 m², walls at least 50 cm high, a lower barrier and a smooth top. These measurements do not replace checks of escape prevention and protection from predators.

Check the house entrance and passage dimensions against the individual animal: species differ in proportions. The body or spines must not become trapped.

Sources: Igelzentrum Zürich, Auswilderung (Freigehege); Pro Igel e.V., Auswilderung von Igelpfleglingen (2022), sections 9– 10; Pro Igel, 1×1 der Igelpflege.